Switching The Authorisation For External Call Transfer Externally On/Off - Auerswald COMpact 4000 Operation Manual

Settings
Transfer and Callback

Switching the Authorisation for External Call Transfer Externally On/Off

This setting can also be made simultaneously for several subscribers. Open
the page Subscribers (Scr.) > Function overview > Analogue settings. In
the required line, click Configure. Continue with step 4 of the following
description.
Proceed as follows:
• Separately for subscribers
• Using the configuration manager
1. Open the page Subscriber (scr.) > Properties.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Click the Analogue settings tab.
4. In the Hook flash timing list field, select one of the following options:
100 ms to 1 s: The PBX detects a signal sent from the subscriber in question
from 100 to 1000 milliseconds as a flash signal.
Switching the Authorisation for External Call Transfer Externally On/Off
If the authorisation for transferring external calls externally is enabled, the subscriber in
question can transfer a call between two external subscribers.
Note: The transferred call is limited to a pre-configured time period (Settings
> Basic settings).
Proceed as follows:
• Separately for subscribers
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
690
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016