Configuring Isdn System Telephones Remotely Via The External S Port On The Pbx (Externally) - Auerswald COMpact 4000 Operation Manual

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring ISDN System Telephones Remotely via the External S
Configuring ISDN System Telephones Remotely via the External S
PBX (Externally)
Important: Before you can configure the system telephones remotely, the
required configurations must first be made via an internal network connection
on the PBX.
Requirements:
• PBX with internal ISDN system telephones
• In the PBX configured remote switching number for system telephones and dealer access
number
– Using the configuration manager (page Settings > Remote configuration)
Note: If no dealer access number has been configured or the phone number
transmitted does not correspond with the configured phone numbers, the
PBX must be enabled via an internal telephone using a digit sequence for
remote configuration.
• An existing external ISDN connection between the PC and the PBX (for example over an
ISDN PC controller at the external S
required for the device on the PC
• Installed COMfortel Set configuration software version 3.0, or later
• Knowledge of the user, sub-admin or admin PIN
• Release of the PBX immediately before remote configuration (see section Short Reference)
if no dealer access number has been configured or the transmission of the configured
numbers is not possible on the computer being used
1. Start the COMfortel Set configuration software.
2. Open the menu Options > Interface....
3. In the Interface list field, select the ISDN card (CAPI 2.0) option.
4. Click OK.
5. Open the menu File > Open.
6. Click Telephone.
724
0
port) including the complete installation of the drivers
0
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Port on the PBX (Externally)
Port on the
0