Do-Not-Disturb; Switching The Do-Not-Disturb Function On/Off - Auerswald COMpact 4000 Operation Manual

Functions

Do-not-disturb

Switching the Do-not-Disturb Function On/Off

Do-not-disturb
The do-not-disturb function offers the option of blocking internal and external calls as well as
blocking group calls on a specific telephone. A caller hears only a busy signal. An internal
subscriber can reach a telephone with call protection in an emergency using a priority call.
The do-not-disturb function has no influence on outgoing calls, callbacks, wake-up calls or
InterCom calls.
Note: As of firmware 6.6 (PBX) and 2.4 (VoIP telephone) a comparison
between telephone and PBX will be implemented. This function can then be
switched on or off in the telephone or the PBX.
Switching the Do-not-Disturb Function On/Off
If do-not-disturb is switched on, calls will not be signalled on the telephone.
Proceed as follows:
• Separately for subscribers
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
• Using the menu/function key on a system telephone (optional, see the telephone manual)
1. Open the following page:
• For admin: Subscriber (scr.) > Properties > Reachability
• For user: Subscriber Properties > Reachability.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Do-not-Disturb check box.
306
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016