Saving The Configuration For Automatic Upload Onto A Usb Memory Stick; Uploading The Configuration Automatically - Auerswald COMpact 4000 Operation Manual

Proceed as follows:
• Using the configuration manager
1. Open the page Administration > Data backup.
2. Click Regenerate under REGENERATE CONFIGURATION.
3. Click Yes.
The configuration is regenerated.

Saving the Configuration for Automatic Upload onto a USB Memory Stick

Requirements:
• USB memory stick formatted with file system FAT, FAT32 or EXT4
• A configuration file saved on the PC (see also chapter Service and Maintenance > Backing
Up and Recovering Configuration Data > Saving Configuration Data on the PC
Note: Any network settings saved in the configuration file will be taken over
during automatic uploading. If the network settings were not saved in the
configuration file, the factory network settings will be retained.
1. Rename the configuration file saved on the PC to auconfig.cfg.
2. Save the configuration file in the root directory of a USB memory stick.
Further steps:
• Perform the automatic upload of the configuration.

Uploading the Configuration Automatically

Proceed as follows:
• Using the PBX
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Backing Up and Recovering Configuration Data
Saving the Configuration for Automatic Upload onto a USB Memory Stick
Service and Maintenance
717