Switching the Search for Available Firmware Updates on/off
If searching for available firmware updates is switched on, the PBX searches the update server
for available firmware updates. Their availability is signalled by a system message when you
log on to the configuration manager (as administrator) or when you open the page Adminis-
tration > Firmware update/restart (as administrator or sub-administrator).
Proceed as follows:
• Using the configuration manager
1. Open the page Settings > Basic settings.
2. Select or clear the Search online for firmware updates check box under
GENERAL.
Requirements to carry out a search:
• PBX connected to broadband Internet access
• Configured address of the update server
• Configured gateway
Update Status
If an update of the PBX has been initiated from the update server, you can view the following
information on the Administration > Firmware update/restart page, in the Update status line
under Firmware update via update server:
• Update status: information about the update that is currently being performed. An error
message appears if the update encounters a problem
• Date of the last update attempt
• Date of the last successful update
Only the update status is displayed (during the update) for system telephone updates.
Note: When you open the page it first shows the status, which is automati-
cally updated every 30 seconds.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Switching the Search for Available Firmware Updates on/off
Service and Maintenance
Firmware Update
707