Creating An Alarm; Creating A Switch Input And Assigning It To The Alarm - Auerswald COMpact 4000 Operation Manual

Creating an Alarm

The alarm must be created in the PBX and assigned an internal number to call and trigger it.
Proceed as follows:
• Using the configuration manager
1. Open the page Devices > Alarms.
2. Click New.
3. Enter a new internal number in the Phone number entry field. Possible entries:
2 to 4 digits in the range of
Note:
Double allocation of a number is not possible.
Using phone numbers with few digits (two or three-digit numbers) inevitably
restricts the possible supply of phone numbers with more digits. For
example, if the phone number 12 is assigned, the phone numbers 120-129
and 1200-1299 are no longer available.
The default exchange line access number on the PBX is 0 in the factory
settings; however, this can be changed. Note that changing the exchange line
access number restricts the telephone numbering plan.
4. Enter a name for the alarm in the Name entry field.
5. Click Save.
Note: To create further configurations for an alarm, click Configure in the line
of the corresponding alarm. The configuration is described in the following.

Creating a Switch Input and Assigning it to the Alarm

An alarm can be assigned switch inputs that can be used to trigger the alarm.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
10 to 9999
Functions
Alarm
Creating an Alarm
291