Creating Switching Times For Switching The Configuration - Auerswald COMpact 4000 Operation Manual

Functions
Configuration Switchover

Creating Switching Times for Switching the Configuration

Note: Using a telephone switch the system relay with operation mode
automatic configuration switchover and the Identification number 900 (factory
settings).
• Using a character string on the internal telephone (see section Short Reference under
relay)
• Using a character string on the external telephone (see section Short Reference under
relay)
• Using the menu/function key on a system telephone (optional, see the telephone manual
under relay)
Requirements:
• Minimum of two configured configurations and configured switching times
• Current PBX time
1. Open the page Time control > Configurations.
2. Select or clear the Automatic configuration switching check box.
Creating Switching Times for Switching the Configuration
A configuration applies until another configuration (manual or automatic) is enabled, also
beyond the daily change. An exception to this would be enabled holidays. When the holiday
ends at 12 a.m., a switch is made back to the regular configuration for that weekday (even if
the configuration was enabled manually on the holiday). At the beginning of the holiday, the
configuration from the day before remains valid until the switchover occurs (automatically or
manually). This means that if, e.g., a holiday is followed by another holiday, the last valid config-
uration for the previous holiday remains enabled until a configuration switchover occurs on the
second holiday.
Note:
An enabled holiday is taken into account from 12 p.m. of the one day until 12
p.m. on the following day.
366
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016