Telephone Number Display (Clip); Switching Clip Information On/Off - Auerswald COMpact 4000 Operation Manual

Telephone Number Display (CLIP)

The phone number display (CLIP) enables the phone number of the caller to be shown on the
display of a system telephone, an ISDN telephone or on a CLIP-capable analogue telephone.
The prerequisite is that the caller transmits a phone number.
A few CLIP-capable analogue telephones support the recording of the date and time in
conjunction with the caller list. On some, it is also possible to display the name instead of or in
addition to the phone number.

Switching CLIP Information On/Off

If CLIP information is enabled, the phone number information (if transmitted) is displayed on
the display of CLIP-capable analogue telephones.
Note:
A caller's phone number (if transmitted) is automatically displayed on ISDN
telephones.
Switching this on/off can also be made simultaneously for several
subscribers. Open the page Subscriber (scr.) > Function overview >
Analogue settings. In the required line, click Configure. Continue with step
4 of the following description.
Proceed as follows:
• Separately for subscribers
• Using the configuration manager
1. Open the following page:
• For admin: Subscriber (scr.) > Properties
• For user: Subscriber Properties.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Click the Analogue settings tab.
4. Select or clear the CLIP info check box under.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Functions
Telephone Number Display (CLIP)
Switching CLIP Information On/Off
437