Toggling Between Conversations; Ending One Of The Two Calls - Auerswald COMpact 4000 Operation Manual

Connecting Both Communication Partners
If you want to let your communication partners speak with each other, you can connect them.
Initiating a Query Call to Third Subscriber
If you want to connect a further communication partner during a query call, you can initiate a
third call for this purpose. Both the first and second communication partner will be on hold in
the background during this time.

Toggling between Conversations

During a query call, proceed as follows:
1. Press the Flash key or the Query key.
2. Dial 2.
You continue to conduct a query call. The other communication partner is now active.
Note:
You can also use this function on analogue telephones, where it can be
performed via the T-Net function key/menu (optional, see manual for the
telephone).
On ISDN and system phones, this function is performed via an existing
function key or via the menu (optional, see manual for the telephone).

Ending One of the Two Calls

If one of your two communication partners hangs up the receiver, you will remain connected
with the other one.
Alternatively, during a query call, proceed as described in one of the following steps.
• Press the Flash key or the Query key and dial 1.
The current call is disconnected.
You will then make an one-to-one call with the communication partner who had previ-
ously been on hold.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Telephoning
Query Calls
Toggling between Conversations
141