Auerswald COMpact 4000 Operation Manual page 311

Max. number of the repetitions per call
Specifies how often the greeting is played if the caller does not input a valid number. The
system react as if the destination was busy/did not reply, after the announcements and the
subsequent waiting time has elapsed.
Waiting time between the announcements or until transfer to the default target
Specifies how long the PBX waits (in seconds) for a valid input between and after the
announcements.
Reaction on busy/on no reply of the destination
If the caller enters a valid suffix dialling digit, the destination subscriber is notified that a call is
present.
If the call is not answered within 120 seconds, the announcement if the destination is busy/
does not reply is played.
If the destination number is busy, the call waiting function is enabled if this function is enabled
for the destination subscriber. If the destination subscriber rejects call waiting, or if they have
not enabled this function, the announcement if the destination is busy/does not reply is played.
The system then reacts in accordance with the setting made here.
End of the call: Three short busy signals are played and the PBX ends the existing call with
the caller.
Call default destination: The PBX transfers the existing call to the default destination number
entered below. If the call is not answered there either, within 120 seconds, three short busy
signals are played and the PBX ends the existing call with the caller.
Note: If the destination number and the default destination number are
identical, the PBX cuts off the call without calling again.
Repeat Automatic Reception: The PBX transfers the existing call to the automatic reception
that was called previously.
Announcement if destination is busy/does not reply
Select the announcement to be played to a caller if the destination is busy or does not reply.
Make your selection from the announcements for automatic receptions and the text before
answering announcements, or do not select an announcement.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Functions
Automatic Reception
Settings for Automatic Receptions
311