Creating A Relais And Assigning It To The Alarm - Auerswald COMpact 4000 Operation Manual

6. Click Ok.
Note: To create further configurations for a switch input, click
the corresponding switch input. The configuration is described in the chapter
Functions > Switch Inputs.

Creating a Relais and Assigning it to the Alarm

Relays with the operating mode Alarm, which are used to enable a siren when the alarm has
been triggered, can be assigned to the alarm. For a detailed description of the operating
modes, refer to the chapter Functions > Relays (Actuators) > Relay Operating Modes,
A relay used for this purpose can, for example, be part of a connected door terminal or another
connected device (e. g. an IP switch relay). The relay is created in the configuration of the PBX
as part of another device and is then assigned to the alarm. It then remains part of this other
device in the configuration of the PBX, but takes over the selected alarm function for the alarm.
Proceed as follows:
• Using the configuration manager
Requirements:
• Relay/actuator (optional, see chapter Important Information > Product Details > Basic
Assembly and Extensions)
• Created alarm
• Created device (e. g. door terminal, IP switch relay) as whose part the relay is to be created
1. Open the page Devices > Alarms.
2. Click the first
Note: If relays have already been configured, a list field will appear now.
Select one of the existing relays and click
of the existing relays, select New relay in the list field.
3. Enter a name for the relay in the Name entry field.
4. Select the device as whose part the relay is to be created in the Add to list field.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
under Switch input+Relay in the line for the corresponding alarm.
Creating a Relais and Assigning it to the Alarm
in the line of
. If you do not want to use any
Functions
Alarm
293