Busy-On-Busy; Switching Busy-On-Busy On/Off - Auerswald COMpact 4000 Operation Manual

Busy-on-Busy

With help of the Busy-on-Busy function, it is possible to define the maximum active call connec-
tions for one group (in single increments until the maximum number of possible external call
channels minus two). If this number has been reached, all additional callers hear the busy
signal. However, members of the group may make additional calls (outgoing calls) if there are
still external call channels available.

Switching Busy-on-Busy On/Off

If Busy-on-Busy is enabled, the number of callers put into the waiting loop automatically is
limited.
Proceed as follows:
• Separately for groups
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
1. Open the page Groups > Properties > Reachability.
2. In the list field at the top, select the group in question by its name or number.
3. In the Busy-on-Busy list field, select one of the following options:
disabled: Disables busy on busy.
busy from x connections on: The number of callers put into the waiting loop
automatically is limited to the number configured here.
Note:
The setting busy from 1 connection on makes sense if e. g. the group is
used to call one user on several telephones.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Functions
Busy-on-Busy
Switching Busy-on-Busy On/Off
317