Identification Number - Auerswald COMpact 4000 Operation Manual

A relay used for this purpose can, for example, be part of a connected device (e. g. door
terminal, IP switch relay). The relay is created in the configuration of the PBX as part of this
device and is then assigned to a function by the selection of an operating mode. It then remains
part of the selected device in the configuration of the PBX.
Proceed as follows:
• Using the configuration manager
Requirements:
• Relay/actuator (optional, see chapter Important Information > Product Details > Basic
Assembly and Extensions)
• Created device (e. g. door terminal, IP switch relay) as whose part the relay is to be created
1. Open the page Devices > Relays (Actuators).
2. Click New.
3. Enter a name for the relay in the Name entry field.
4. In the Add to list field, select the device as whose part the relay is to be created.
5. Click Save.
Note: To create further configurations for a relay, click
corresponding relay. The configuration is described in the following.

Identification Number

For manual switching of a relay by a programming sequence or remote switching the number
(2 to 4 digits) defined here is necessary.
Note: All previously assigned identification numbers can be viewed sorted by
number, name or type under Overviews > Identification number table.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Functions
Relays (Actuators)
Identification Number
in the line of the
427