Switching Automatic Updating Of The Pbx Time After Each Isdn Call On/Off - Auerswald COMpact 4000 Operation Manual

Requirements:
• PBX connection to the server network
• Disabled automatic updating of the PBX time after each ISDN call
1. Open the page Settings > Date/Time of the PBX.
2. In the Update interval list field under From the Internet from an NTP server, select
one of the available options.
Note: The automatic updating of the PBX time via the network is performed
at the selected time interval (e.g., every 5 hours).
3. Select or enter an NTP server:
• Click the Country option button and select the desired country from Country the
list field. Finally, select the desired server from the NTP server list field.
• Click the Manual server option button. Enter the address of a local NTP server or
the name of an external NTP server in the Manual server entry field. Enter the
port in the Port entry field.
Note: You should receive the address from the system administrator of the
network.

Switching Automatic Updating of the PBX Time after Each ISDN Call On/Off

If updating the PBX time after each ISDN call is enabled, the time transmitted by the network
provider during an outgoing external call is used for setting the PBX time.
Note:
The network provider usually transmits a time that is precise to the minute.
The time is updated at most once per hour.
Proceed as follows:
• Using the configuration manager
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Switching Automatic Updating of the PBX Time after Each ISDN Call On/Off
Settings
PBX Time
663