Connecting Isdn End Devices Directly To The Internal U P0 Port - Auerswald COMpact 4000 Operation Manual

Note: For a short passive bus in two directions or a short passive bus with
star topology, equip the wall sockets on both ends with terminators.
Further steps:
• Connect the end devices to the wall sockets.
• To finish commissioning, you need to set up an internal number for the end device in the
configuration manager.
Connecting ISDN End Devices Directly to the Internal U
Requirements:
• Cover panel is removed
• Enabled operating mode "U
Note: The default setting is „S
• Terminators switched on at the internal U
• Short distances between the devices (maximum length of the connection cable used: 10 m)
Note: If the end device is placed a larger distance away from the PBX, the
cable and the wall sockets must be permanently installed.
• U /S adapter
P0 0
Note: For connecting one single COMfortel 1200/1400/1600/2600 system
telephone, a U
Depending on the type and number of end devices, proceed as follows.
• Single COMfortel 1200/1400/1600/2600:
a) Connect the system telephone to the RJ-45 socket on the internal U
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
internal" on the U
P0
external" for port 1 and „S
0
port
P0
/S adapter is not necessary.
P0 0
Installation and Commissioning
Connecting ISDN End Devices Directly to the Internal U
Port
P0
port in question
P0
0
ISDN End Devices
Port
P0
internal" for port 2.
port.
P0
83