Auerswald COMpact 4000 Operation Manual page 111

Network Configuration
Before the PBX can be reached in the network, it must first be prepared for network access by
a number of settings.
Changes to the network configuration (IP address static or via DHCP) are only saved at first,
but not enabled. They will only be enabled when you leave the configuration wizard using step
11, End, or the symbol
are to be enabled immediately or after a restart of the PBX.
If you have saved your changes by clicking
page), you must first restart the PBX before the changes to the network configuration are
enabled.
ETHERNET CONFIGURATION
IP address
Note: IPv6 address cannot be entered using the configuration wizard.
You can make further settings under Administration > IP configuration.
For further information, click
Port Configuration
An external S port can be used for the following types of connections:
0
• PTMP connection: ISDN PTMP connection with up to ten multiple subscriber numbers
(MSNs).
• PTP connection: ISDN PTP connection with PBX base number and Direct Dial In numbers
(DDI numbers).
You can make further settings under Hardware > Port configuration.
For more information, click one of the help topics.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
. A dialogue appears which allows you to decide whether the changes
Save or Save and continue (when leaving the
IP address of the PBX
Number of digits: as for an IPv4 address with the
blocks from 0 to 255
Factory setting: IP address received automatically
(DHCP client) and enabled permanent IP address
169.254.1.240 from the APIPA address range.
or one of the help topics.
Introduction to the Configuration Manager
Configuration Manager
Configuration Wizard
111