Switching The Busy Tone For The End Of Call On/Off; Switching The Special Dial Tone On/Off - Auerswald COMpact 4000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 4000:

Table of Contents

Switching the Busy Tone for the End of Call On/Off

If busy signal for end of call is enabled, the PBX generates a busy signal at the end of the call

(e.g., the communication partner hangs up).

For some answering machines, this busy signal does not interrupt a recording. These

answering machines cannot differentiate between the busy signal and speech. For such cases,

the busy signal can be disabled.

Proceed as follows:

• Separately for subscribers

• Using the configuration manager

1. Open the following page:

• For admin: Subscriber (scr.) > Properties > Settings

• For user: Subscriber Properties > Settings.

2. In the list field at the top, select the subscriber in question by his name or number.

3. Select or clear the Busy tone at end of call check box under Signallisation by

If the special dial tone is enabled, the PBX generates a special dial tone to bring attention to a

configured function (do-not-disturb, baby call (connection without dialling)) or that call data

memory has reached capacity.