Entering Dtmf Sequences To Control A Door Terminal - Auerswald COMpact 4000 Operation Manual

If a door call should also be executed via VoIP accounts or GSM gateways,
in any case the external number must be entered with the corresponding city
code, even if it is the local prefix.
16. Click Save.
17. Click Close.
Further steps:
• Add the phone number you have just entered to the SIP settings of the door terminal. Enter
the PBX as domain, registrar, etc. of the VoIP door terminal.
Note:
To change the settings of the just created door terminal, click Configure in
the line of the corresponding door terminal on the page Devices > Device
wizard.
To create further configurations for a door terminal, open the page Devices
> Door terminals and click Configure in the line of the corresponding door
terminal. The configuration is described in the following.
To reset the door terminal to the default settings of the device template,
delete the door terminal on page Devices > Device wizard and create the
door terminal again.

Entering DTMF Sequences to Control a Door Terminal

The PBX uses DTMF sequences to control the analogue door terminals. For this purpose, the
PBX needs to know which DTMF sequences the connected device requires to enable or
terminate the connection (see the manual of the device in question).
Proceed as follows:
• Separately for door terminals
• Using the configuration manager
Requirements:
• Created analogue door terminal
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Entering DTMF Sequences to Control a Door Terminal
Functions
Door Functions
483