Entering Dtmf Sequences To Control The Announcement Output - Auerswald COMpact 4000 Operation Manual

5. In the Module and Port list fields, select the module and the port to which the device
that can be used as announcement output (e. g. an a/b-Audiobox at a loudspeaker
system) is connected.
6. Click Save.
7. Enter a new internal number in the Phone number entry field. Possible entries:
2 to 4 digits in the range of
Note:
Double allocation of a number is not possible.
Using phone numbers with few digits (two or three-digit numbers) inevitably
restricts the possible supply of phone numbers with more digits. For
example, if the phone number 12 is assigned, the phone numbers 120-129
and 1200-1299 are no longer available.
The default exchange line access number on the PBX is 0 in the factory
settings; however, this can be changed. Note that changing the exchange line
access number restricts the telephone numbering plan.
8. Click Save.
9. Click Close.
Note: To create further configurations for an announcement output, open the
page Devices > Announcement outputs and click Configure in the line of
the corresponding announcement output. The configuration is described in
the following.

Entering DTMF Sequences to Control the Announcement Output

The PBX uses DTMF sequences to control the analogue announcement outputs. For this
purpose, the PBX needs to know which DTMF sequences the connected device requires to
enable or terminate the connection (see the manual of the device in question).
Proceed as follows:
• Separately for announcement outputs
• Using the configuration manager
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Entering DTMF Sequences to Control the Announcement Output
10 to 9999
Functions
Loudspeaker Announcement
377