Auerswald COMpact 4000 Operation Manual page 701

The Power LED remains lit in green until all of the calls are terminated or until the end
of the waiting time. If all calls, all connections to/from the web server and all data
services are terminated, the PBX will perform a restart (even before the defined time
has elapsed). If a call (a connection) is active after the time has elapsed, this call will
be interrupted to perform the restart.
The Power LED lights up/flashes in red and orange for up to two minutes.
If the Power LED lights up in green again, the restart is complete and the PBX is
ready for operation.
Note: If the Power LED remains continuously lit in red, an error has occurred.
Please contact your dealer or the manufacturer directly.
Performing a Restart Immediately by Pressing a Button
Warning: Touching voltage-carrying conductors or telephone connections
can cause life-threatening electric shocks.
• For some installation and maintenance work, it is necessary to open the
• Only a qualified electrician may perform installation work within an open
Warning: Power surges, which can occur during electrical storms, can
cause life-threatening electric shocks and damage or destroy the PBX.
• Do not open the PBX during an electrical storm.
1. Press the Reset button on the COMpact 4000 interface board.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
PBX while it is in operation (qualified electrician only). Make sure that the
PBX is never left unattended while working with an open casing. Close
the casing after completing this work.
casing or service work using the buttons inside the casing. If necessary,
commission a specialised dealer to perform this work.
Service and Maintenance
Restart
Performing a Restart
701