Configuring Access Authorisation; Configuring Administrator Access - Auerswald COMpact 4000 Operation Manual

Settings
Protection from Unauthorised Access

Configuring Access Authorisation

Users (internal subscribers)
The user is any internal subscriber of the PBX that may receive additional authorisations by
assigning a user PIN. The access authorisations to the Web interface are assigned to the user
by the administrator according to local requirements. The possible range of page releases is
limited to a very small number of own subscriber and group settings.
Each user has the same access authorisations. There modification rights may differ depending
on the profiles.
Configuring Access Authorisation
Proceed as follows:
• Using the configuration manager
1. Open the page Administration > Access authorisations.
2. Click next to the required page to list all subpages.
3. Select or clear all check boxes for the pages to which sub-admin and user shall have
access.

Configuring Administrator Access

You must enter the user data for administrator access when you set the device up for the first
time. You can change them if required.
Note:
Changes at the administrator access are only possible with an encrypted
connection (https).
To make any changes, you need the current admin password.
After a change you must log in again.
Proceed as follows:
• Using the configuration manager
676
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016