Switching Extended Clip Information On/Off - Auerswald COMpact 4000 Operation Manual

Functions
Telephone Number Display (CLIP)

Switching Extended CLIP Information On/Off

Switching Extended CLIP Information On/Off
If extended CLIP information is enabled, the date and time on CLIP-capable analogue
telephones is recorded in conjunction with their caller list. The PBX can make this information
available so that the date and time of previous calls are displayed in the caller list when
scrolling. Some analogue telephones can also display CLIP information alpha-numerically. In
this case, the PBX compares the transmitted phone number with the short-code numbers
saved in the PBX. If an identical phone number is found, the name saved in the PBX is also
displayed in addition to the phone number information.
Note:
For some end devices, extended CLIP information can cause problems and
should therefore be disabled.
Switching this on/off can also be made simultaneously for several
subscribers. Open the page Subscribers (Scr.) > Function overview >
Analogue settings. In the required line, click Configure. Continue with step
4 of the following description.
Proceed as follows:
• Separately for subscribers
• Using the configuration manager
Requirements:
• CLIP info enabled for the subscriber
1. Open the following page:
• For admin: Subscriber (scr.) > Properties
• For user: Subscriber Properties.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Click the Analogue settings tab.
4. Select or clear the Extended CLIP info check box.
438
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016