Auerswald COMpact 4000 Operation Manual page 109

Note: To open the configuration wizard you must be logged in to the PBX as
administrator.
Navigating in the Configuration Wizard
You can navigate in the configuration wizard as follows:
• Using symbols: The following symbols are available in the toolbar of the configuration
wizard:
Opens the next page of the configuration wizard.
Opens the previous page of the configuration wizard.
• Clicking with the left mouse key: Clicking allows you to carry out the corresponding step
directly.
There is no obligatory sequence to the steps.
Note: The steps 3, Network configuration, to 11, End and the button
Continue are only available if you have entered an admin user password, an
admin PIN and an admin password in step 2, Dealer/operator data.
Saving Settings
In principle, all data entered is saved immediately as soon as you click the next step.
Note: Modifications of the network configuration (IP address static or via
DHCP client) are only stored at first, but not enabled. They will only be
enabled when you leave the configuration wizard using step 11, End, or the
symbol
Saves changes.
Page remains open.
Saves changes.
Opens next page.
Clicking any Saves changes upon confirmation.
step
Opens the page.
11. End Saves changes upon confirmation.
Activates network configuration upon confirmation either immediately or after
a restart of the PBX.
Closes the configuration wizard.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
.
Introduction to the Configuration Manager
Configuration Manager
Configuration Wizard
109