Auerswald COMpact 4000 Operation Manual page 295

Alarm subscriber (destination number) x
Select up to four internal or external phone numbers to be called when the PBX performs an
alarm loop.
Entering the destination number: Use this to enter a phone number manually.
Possible entries:
External number
Short-code dialling number
Internal number of the individual telephone
Internal number of the group
Notes:
The default exchange line access number on the PBX is 0 in the factory
settings. However, this can be changed.
You can set the display text that will be displayed if an alarm call is made to
the internal subscribers, which have been selected as alarm subscribers,
here (see Settings > CLIP texts).
Exchange line dialling / DDI number
---: Alarm calls can be made on all external channels.
External connection: alarm call is made on the selected external connection. The selected
phone number is transmitted.
Notes:
You must select the DDI number to be sent for a PTP connection from the
extensions block. If the DDI number is then displayed in red text, either it is
not in the value range, or the maximum number of external phone numbers
has already been entered.
Alarm calls should preferably be made via the land line.
Alarm delay time
Specifies how many seconds elapse, after the alarm is triggered on the switch input, before the
first alarm loop starts.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
0 to 99
presentation
Functions
Alarm
Alarm Settings
295