Auerswald COMpact 4000 Operation Manual page 535

• Transfer to IPv4 whitelist or Transfer to IPv4 whitelist to delete the IP address
from the IP blacklist and move it to the IP whitelist.
Setting up an IP Whitelist
Proceed as follows:
• Using the configuration manager
1. Open one of the following pages:
• Administration > IP black- and whitelist > IPv4 blacklist
• Administration > IP black- and whitelist > IPv6 blacklist
Note: The IPv6 whitelist will only be displayed, if the use of IPv6 has been
enabled (Administration > IP configuration.
2. Click New.
3. Enter a new IP address in the IP address entry field. Possible entries:
Four blocks with three digits for IPv4 addresses
Eight blocks with four digits or characters for IPv6 addresses
4. Enter the corresponding data in the Net mask and Prefix entry fields. Possible
entries:
Four blocks with three digits for IPv4 subnet mask
Digits 1
Note: The subnet mask is entered automatically for a network computer
when you click Network calculator. You can then also set the CIDR suffix
and so the CIDR notation.
The values for Host IP appear automatically in the list.
5. Click Save.
6. Repeat steps 2 to 5 to enter additional IP addresses.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
IP Blacklist and Whitelist as Protection Against Attacks from the Internet
to 128 for prefix
Settings
Internet Access
535