Table of Contents
Advertisement
2. Enter an internal number in the Internal base number entry field. Possible entries:
2 to 3 digits in the range of
Note:
Double allocation of a number is not possible.
Using phone numbers with few digits (two or three-digit numbers) inevitably
restricts the possible supply of phone numbers requiring more digits.
For example, if the phone number 12 is assigned, the phone numbers 120-
129 and 1200-1299 are no longer available.
The default exchange line access number on the PBX is 0 in the factory
settings; however, this can be changed. Note that changing the exchange line
access number restricts the telephone numbering plan.
3. Enter the corresponding name in the Name entry field.
Configuring Hold Time
The hold time indicates how many minutes a call is kept in the internal parking zone at most.
After the hold time has elapsed, the subscriber that put the call in the parking zone is again
signaled that the call is still there. If this subscriber is busy, the call is put back on hold in the
parking zone. If the hold time elapses a second time without the call being transferred, the
connection is disconnected and the caller hears the busy signal.
Proceed as follows:
• Using the configuration manager
1. Open the page Functions > Call parking.
2. Enter a value in the Hold time entry field. Possible entries:
1
to 20: A call is held for a maximum of 1 to 20 minutes in the internal parking
zone.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
10
to
999
Functions
Call Parking
Configuring Hold Time
393
- Quick Links:
- Configuration and Administration
Hide quick links:
Advertisement
Table of Contents
