Installing Tapi Driver (Tsp) - Auerswald COMpact 4000 Operation Manual

Installing TAPI driver (TSP)

The PBX must be connected with a server PC via a TCP/IP network. The TAPI driver (TSP)
that belongs to the PBX must be installed on this server PC from the Auerswald Mega Disk.
Important: If you want to integrate the LAN-TAPI into an existing network,
please contact the system administrator responsible for this. Making changes
to an existing network may cause considerable functional disturbances.
Note: You can find the current version of the driver on the Internet (see
www.auerswald.de/service).
Requirements:
• A driver file (*.exe) in its current version saved on a data storage device (PC)
• Server PC that fulfils one of the following minimum requirements:
- Windows 2008 Server 32/64-bit
- Windows 2008 Server R2 64-bit
- Windows 7 32-/64-bit
- Windows 8/8.1 32-/64-bit
- Windows 2012 Server
- Terminal server: Windows 2008 32/64-bit
1. Start driver file (*.exe) on the server PC.
The TAPI driver installation is started.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Caution: A high level does not necessarily indicate a secure
password as this can also be reached by entering names and birth
dates in connection with special characters. However, names and
birth dates should not be used as passwords.
• To create a secure password you can consult, for example, the
guidelines of the German Federal Office for Information Security
(BSI, in German).
Caution: Visible passwords constitute a security risk.
• After entering the PIN/password, click on
Functions
LAN-TAPI
Installing TAPI driver (TSP)
Mask passwords.
373