Connecting The Ethernet Port With The Internet/Lan - Auerswald COMpact 4000 Operation Manual

Note: When assigning the individual wires, orientate yourself with the identi-
fiers listed below, or refer to VDE 0815 when identifiers deviate.
Physical circuit/
pair 1
Physical circuit/
pair 2
2. Connect the NTBA to the four terminal clamps on the external S

Connecting the Ethernet Port with the Internet/LAN

Requirements:
• Minimal distance between the devices
• For Internet access: Broadband Internet connection (e. g. DSL router, TV cable router)
• For LAN access: Existing network (LAN) with the following characteristics:
– Data transmission rate 100 Mbit/s
Note: For VoIP data communication in combination with the transmission of
limited amounts of data, a data transmission rate in the LAN of 10 Mbps is
sufficient under certain circumstances. For VoIP data communication in
combination with the transmission of large amounts of data (e. g.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Cable with Two
Twin Wires
a1 red
b1 black
a2 white
b2 yellow
Installation and Commissioning
Connecting the Ethernet Port with the Internet/LAN
Cable with Star Quad
without ring
single rings, 17 mm spacing
double rings, 34 mm spacing
double rings, 17 mm spacing
port.
0
Network Provider
71