Creating Configurations - Auerswald COMpact 4000 Operation Manual

Proceed as follows:
• Separately for subscribers
• Using the configuration manager
1. Open the page Subscriber (scr) > Properties > Authorisations.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Configuration switching check box.

Creating Configurations

A maximum of ten configurations can be created.
Proceed as follows:
• Using the configuration manager
1. Open the page Time control > Configurations.
2. Click New.
3. Enter the name of the configuration in the Configuration name entry field.
4. In the Based on list field, select a template from all configurations created so far.
5. Click Save.
6. In the Configuration dependent settings column select the check boxes for the
settings that are to be copied from the template.
7. Click Save.
8. Click Close.
9. If necessary change the identification number for the configuration in the Identifi-
cation number entry field. Possible entries:
2 to 4 digits
Note: All previously assigned identification numbers can be viewed sorted by
number, name or type under Overviews > Identification number table.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Functions
Configuration Switchover
Creating Configurations
363