Switching Authorisation For Controlling The Pbx On/Off - Auerswald COMpact 4000 Operation Manual

Settings
Protection from Unauthorised Access

Switching Authorisation for Controlling the PBX On/Off

Requirements:
• Authorisation Controlling of the PBX via telephone assigned to the subscriber
• Knowledge of the required PIN
1. Pick up the receiver.
2. Dial *99*.
3. Enter the existing PIN.
4. Dial *.
5. Enter the new PIN. Possible entries:
Exactly 6 digits
Digits
Note:
All of the PINs in the PBX are unique. This means that it is not possible to
allocate the same PIN twice.
Do not use dates of birth or dates as PINs. This makes it easy for an attacker
to find out the correct PIN. PINs which are easy to guess, such as 111111 or
123456, should also be avoided.
6. Dial *.
7. Re-enter the new PIN.
8. Dial #.
Note: If, at this point, you hear a busy signal instead of a confirmation tone,
the new PIN may already be in use in the PBX and no change takes place.
Re-attempt with another digit sequence.
Switching Authorisation for Controlling the PBX On/Off
If authorisation for controlling the PBX via telephone is enabled, the subscriber in question
program the PBX over the internal telephone.
682
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016