Auerswald COMpact 4000 Operation Manual page 565

Tones
Dial tone 1 (normal dial tone)
Dial tone 2 (special dial tone)
Dial tone 3 (Centrix tone)
Busy signal 1 (call target busy)
Busy signal 2 (network busy)
Call tone 1
Call tone 2
Special interest tone
The character strings show which tones are sent by the analogue network provider. This means
the PBX can then identify the tones and apply them accordingly.
The network provider uses these tones in the following situations:
• Dial tone: When a subscriber picks up the call.
• Busy signal: If the required connection is busy (busy signal 1), or if the network is
overloaded (busy signal 2, e.g. directly after dialling the local area code).
• Call tone: During the call phase.
• Special interest tone: If the dialled phone number is not present, and the network provider
has not recorded a special announcement for this situation.
Notes:
Please contact the Support team before making any changes to these
character strings.
An incorrect character string will cause the PBX to operate incorrectly.
Ring Signal
Frequency
The ringer frequency specifies which frequency is used by the analogue network provider to
send the ring signal.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Analogue Connection
Expert Configuration, Analogue Connection
Settings
565