Identification; Switching The Dhcp Client On/Off; Configuring The Ipv4 Address Of The Pbx - Auerswald COMpact 4000 Operation Manual

Identification

The PBX is integrated into an existing network. To make sure the PBX can be identified in this
network, several settings must be configured.

Switching the DHCP Client On/Off

If the DHCP client function has been enabled, the PBX automatically receives its IP address
from an DHCP server.
Note: In the factory settings, DHCP is enabled.
Proceed as follows:
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
1. Open the page Administration > IP configuration.
2. Select or clear the Receive the IP address automatically (DHCP client) check box
under ETHERNET CONFIGURATION.

Configuring the IPv4 Address of the PBX

Proceed as follows:
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
Requirements:
• Disabled DHCP client
1. Open the page Administration > IP configuration.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Settings
Identification
Switching the DHCP Client On/Off
525