Auerswald COMpact 4000 Operation Manual page 611

LCR
Requirements:
• Network provider must support the dial-around service
• Configured prefixes (country prefix and local area code)
• Configured LCR (see Functions > LCR section)
The VoIP account is used for LCR calls.
Notes:
LCR must be disabled if the network provider does not support LCR.
However, you can always perform LCR manually by dialling a provider area
code prefix if the network provider supports the dial-around service.
Routing via exception numbers (VoIP + GSM + LCR)
Requirements:
• Exception numbers (VoIP/GSM routing) are set up
The device checks whether the destination number involved in call forwarding for external
numbers has been set up as an exception number. If so, the call is sent along the configured
path. If the destination number has not been entered in the routing table, the call to be
forwarded is sent either via a VoIP call channel or via any free call channel (For call
forwarding via the PBX, use any available call channel).
PHONE NUMBERS FOR PTP CONNECTION
PBX base number
Extensions block (DDI numbers)
Requirements:
• prefixes (country and local area code) configured for the VoIP account
A PTP connection has a PBX base number (base number, header, base phone number) and
(Direct Dial In - DDI) extension numbers. The VoIP provider assigns the phone numbers for the
connection. The phone number to be dialled is formed from the PBX base number + DDI
number.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
From To
Settings
VoIP
VoIP Account Settings
611