Auerswald COMpact 4000 Operation Manual page 292

Functions
Alarm
Creating a Switch Input and Assigning it to the Alarm
A switch input used for this purpose can, for example, be part of a connected door terminal
(e. g. a still free door bell button). The switch input is created in the configuration of the PBX as
part of another device and is then assigned to the alarm. It then remains part of this other device
In the configuration of the PBX, but takes over the selected alarm function the alarm.
To detect that the alarm has been triggered, e. g. because a door bell button has been pressed,
the PBX needs to know which DTMF sequence or which SIP invite the connected device sends
in this case (see manual and settings of the device in question).
Note: The DTMF sequence or the SIP invite usually is the phone number
assigned to the door bell button within the door terminal.
Proceed as follows:
• Using the configuration manager
Requirements:
• Switch input (optional, see chapter Important Information > Product Details > Basic
Assembly and Extensions)
• Created Alarm
• Created device (e. g. a door terminal) as whose part the switch input is to be created
1. Open the page Devices > Alarms.
2. Click the second
alarm.
Note: If switch inputs have already been configured, a list field will appear
now. Select one of the existing switch inputs and click
to use any of the existing switch inputs, select New switch input in the list
field.
3. Enter a name for the switch input in the Name entry field.
4. Enter the DTMF sequence/SIP invite which the connected device uses as signal in
the DTMF sequence / SIP invite entry field. Possible entries:
Digits and the characters * and #
5. Select the device as whose part the switch input is to be created in the Add to list
field.
292
under Switch input+Relay in the line for the corresponding
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
. If you do not want