Analogue End Devices; Kabel Und Anschlussdose Am Internen A/B-Port Verlegen - Auerswald COMpact 4000 Operation Manual

Pbx for analogue/isdn/internet telephony
Hide thumbs Also See for COMpact 4000:
Table of Contents

Advertisement

Installation and Commissioning

Analogue End Devices

Kabel und Anschlussdose am internen a/b-Port verlegen

Analogue End Devices
This section describes the connection of different analogue end devices to the a/b port. If at all
possible, a difference is made between a device to be connected directly and lines to be laid
permanently.
Warning: Touching voltage-carrying conductors or telephone connections
can cause life-threatening electric shocks.
• The PBX contains hazardous voltages, even outside the power supply
• Pull out the power plug of the PBX before instructing a qualified
Important: Improper use can cause, for example, functional restrictions or
interference, the destruction of the device or, in a worst-case scenario,
personal injury.
• Only connect equipment that is compatible with the proper use of the
Kabel und Anschlussdose am internen a/b-Port verlegen
Requirements:
• Cover panel is removed
• Maximum distance/line length between the devices depending on the cable used (with a
pair diameter of 0.6 mm: approximately 800 m )
• Per a/b port, one wire pair of an installation cable (e. g. J-Y(St)Y 2x2x0.6)
• Under unfavourable conditions, for example, near a strong transmitter or an electrical
power line: screened cable
• For telephones or combination fax/answering machines: a TAE wall socket with F coding (a
single socket labelled with an F)
• For fax machines, modems, and call answering machines: a TAE wall socket with an
additional socket with N coding
74
unit (for instance ringer voltages). Work on active, contact-hazardous
parts is only permitted after creating a voltage-free state. Working close
to active parts is only permitted if these parts are voltage-free or are
protected against direct contact
electrician to open the casing to install the expansion module or perform
switching or connecting services.
PBX.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents