Configuring The Billing Factor - Auerswald COMpact 4000 Operation Manual

Address Books and Lists
Call Data

Configuring the Billing Factor

The value entered here refers to the currency entered under Currency name (e.g., for the
Currency name EUR
Note:
For Least Cost Routing (LCR), the tariff information of dial-around providers
is saved in the PBX. This data (prices + charge pulse interval) replace the
cost per call unit entered here for all LCR calls.
If using an analogue exchange line or a VoIP account for external calls, no
charges will be displayed.
Proceed as follows:
• Using the configuration manager
1. Open the page Functions > Call allowance accounts.
2. Enter a value in the Price per unit entry field. Possible entries:
Price in 00.0000 format: Specifies the cost per call unit from 0.0000 to 99.9999.
Digits and the separator
Configuring the Billing Factor
The billing factor indicates the value used to convert the subscriber's telephone costs.
This factor is used to multiply the charges transmitted from the network provider or the calcu-
lated charges. The telephone costs calculated in this way are used in the call data list.
Proceed as follows:
• Separately for subscribers
• Using the configuration manager
1. Open the page Subscribers (scr.) > Properties > Settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Enter a value in the Billing factor entry field. Possible entries:
208
0.0600 for 6 cents).
,
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016