Entering The Sip Invite - Auerswald COMpact 4000 Operation Manual

Functions
Switch Input

Entering the SIP Invite

• Devices > Door terminals
• Devices > Alarms
2. Click in the line of the corresponding door call/switch input.
3. Enter the DTMF sequence which the connected device uses as signal in the DTMF
sequence entry field. Possible entries:
Digits and the characters * and #
Entering the SIP Invite
The PBX can detect the actuation of a door bell button, for example, and then trigger an alarm
or a door call. To detect the actuation of a door bell button, the PBX needs to know which SIP
invite the connected device sends in this case (see manual and settings of the device in
question).
Note: The SIP invite usually is the phone number assigned to the door bell
button within the door terminal.
Proceed as follows:
• Separately for switch inputs
• Using the configuration manager
Requirements:
• Created VoIP switch input
1. Open one of the following pages:
• Devices > Door terminals
• Devices > Alarms
2. Click in the line of the corresponding door call/switch input.
3. Enter the SIP invite which the connected device uses as signal in the SIP invite entry
field. Possible entries:
Digits and the characters * and #
464
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016