Alarm Settings - Auerswald COMpact 4000 Operation Manual

Functions
Alarm

Alarm Settings

5. Click Ok.
Note: To create further configurations for a relay, click
corresponding relay. The configuration is described in the chapter Functions
> Relays (Actuators).
Alarm Settings
Proceed as follows:
• Separately for alarms
• Using the Configuration Manager (page Devices > Alarms > Configure)
Requirements:
• Configured alarm
CONFIGURING THE ALARM
Select the alarm you want to configure.
Enable alarm
off: The alarm input is disabled.
once: The alarm can be initiated only once. Subsequently, the alarm input will be disabled and
will have to be enabled once again.
always: After an alarm is triggered off, the alarm input continues to be enabled. A further alarm
can be triggered off.
Number of alarm loops
Specifies how many alarm loops are to be performed before the alarm is acknowledged.
Alarm announcement
Select the announcement to be played to alarm subscribers.
294
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
in the line of the