Configuring The Use Of The External Analogue Ports - Auerswald COMpact 4000 Operation Manual

Settings
Hardware

Configuring the Use of the external analogue Ports

1. Open the page Hardware > Port configuration.
2. Select or clear the S0 bus monitoring check box.
Configuring the Use of the external analogue Ports
Proceed as follows:
• Using the configuration manager
Requirements:
• Selected COMpact 2FXO module
1. Open the page Hardware > Port configuration.
2. Under Use, select one of the following options:
free: Port is not used.
external: Port is used as external port.
Note:
If the settings for the module are marked in red, the module is selected but
not inserted.
The numbers under Port correspond to the numbers used on the board.
Further steps:
• If necessary, change the country-specific settings (see chapter Settings > Analogue
Connection > More Information on Country-specific Settings).
524
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016