Commissioning; Turning On The Pbx; Connecting The Pc To The Ethernet Port Of The Pbx - Auerswald COMpact 4000 Operation Manual

Installation and Commissioning

Commissioning

Turning on the PBX

Commissioning
This section describes the commissioning of the PBX. This includes turning on the PBX, setting
up the network connection between the computer and the PBX as well as logging into the web
interface on the PBX for setting up the initial configuration. After this, you will learn how to put
each individual end device into operation.
Turning on the PBX
Requirements:
• PBX connected to earthing and casing closed (see chapter Installation and Commissioning
> Preparation (COMpact 4000) > Connecting to Earthing)
Warning: Touching voltage-carrying conductors or telephone connections
can cause life-threatening electric shocks.
• Close the casing before you put the PBX into operation.
• Connect the PBX to a freely accessible Schuko socket.
The Power and Status LEDs light up several seconds/minutes in red and orange.
When the LEDs light up in green, the PBX is ready for operation.
Note:
If the Power LED remains continuously lit in red, an error has occurred.
Please contact your dealer or the manufacturer directly.
Switching off and powering down the PBX is described in detail in the chapter
Service and Maintenance > Powering Down and Switching Off.

Connecting the PC to the Ethernet Port of the PBX

Requirements:
• For direct connection to the Ethernet port: Short distance between the devices
• A patch cable
92
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016