Selecting The Language - Auerswald COMpact 4000 Operation Manual

End
You can leave the configuration wizard with this step.
Alternatively, you can leave the configuration wizard by
Notes:
Any changes made on the current page will not be saved if you leave the
configuration wizard using the symbol
Changes to the network configuration (IP address static or via DHCP client)
were only saved at first, but not enabled. They will only be enabled when you
leave the configuration wizard using step 11, End, or the symbol
dialogue appears which allows you to decide whether the changes are to be
enabled immediately or after a restart of the PBX.
If you want to change or expand your settings after leaving the configuration wizard, open the
configuration wizard again or go to the page referenced in each individual step.

Selecting the Language

You can select the language for the configuration manager.
Proceed as follows:
• Using the configuration manager
1. Open the page Administration > IP configuration.
2. Select the desired language in the Language list field under Server configuration.
deutsch
english
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Introduction to the Configuration Manager
.
.
Configuration Manager
Selecting the Language
. A
115