Call Restrictor (Outgoing) - Restricted Numbers; Switching The Call Restrictor (Outgoing) On/Off For Subscriber - Auerswald COMpact 4000 Operation Manual

Call Restrictor (outgoing) – Restricted Numbers
In order to restrict exchange line authorisation, the phone numbers that should not to be dialled
can be put in call restrictors. There are several ways to do this. In general, phone numbers are
restricted that begin with a certain digit sequence and that should not be accessible to every
subscriber due to its higher charge tariffs, e.g., 0900 phone numbers. Normally, the first 4 to 5
digits indicate the telephone service that cause such high charges.
If an attempt is made to dial a restricted phone number, only a busy signal is heard. If the
restricted numbers are not enabled (meaning "not restricted"), restriction via the configured
exchange line authorisation is still possible.

Switching the Call Restrictor (Outgoing) On/Off for Subscriber

If a call restrictor (outgoing) is enabled for a subscriber, the subscriber can not dial the phone
numbers entered in the call restrictor irrespective of his exchange line authorisation.
For a single subscriber, the configuration can be made for business and private calls
separately.
Proceed as follows:
• Separately for subscribers
Note: If differently configurable functions for private and business calls are
enabled, two different configurations can be created for each subscriber –
one for private calls and one for business calls (see also chapter Functions >
Private (Personalised) Exchange Line Access > Switching Differently Config-
urable Functions for Private and Business Calls On/Off).
• Separately for configurations
• For the exchange line transfer function (Settings > Basic settings > EXCHANGE LINE
CALL TRANSFER > Exchange line settings for the manually switched exchange line
access > Configure special exchange line settings > Configure)
• For the Call Through function (Functions > Call Through > EXCHANGE LINE SETTINGS
> Configure)
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Call Restrictor (outgoing) – Restricted Numbers
Switching the Call Restrictor (Outgoing) On/Off for Subscriber
Functions
465