Configuring The Ipv4 Subnet Mask; Configuring The Ipv4 Gateway - Auerswald COMpact 4000 Operation Manual

Settings
Identification

Configuring the IPv4 Subnet Mask

2. In the IP address entry field under ETHERNET CONFIGURATION, enter the IPv4
address of the PBX. Possible entries:
IP address with a range of 0 to 255 (example: 192.168.0.240)
The dialogue for applying the setting appears.
3. Clicke of the following buttons:
Apply immediately: The IPv4 address is immediately applied and the PBX is
routed to the new IPv4 address. After the rerouting, you need to log in again.
Apply at restart: The IPv4 address is not applied until the next time the PBX is
restarted.
Configuring the IPv4 Subnet Mask
Proceed as follows:
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
Requirements:
• Disabled DHCP client
1. Open the page Administration > IP configuration.
2. In the Sub-network mask entry field under ETHERNET CONFIGURATION, enter
the subnet mask. Possible entries:
IPv4 address (e.g.: 255.255.255.0)

Configuring the IPv4 Gateway

TProceed as follows:
• Using the configuration manager
• Using a character string on the internal telephone (see section Short Reference)
526
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016