Ending A Query Call; Options During A Query Call - Auerswald COMpact 4000 Operation Manual

Telephoning
Query Calls

Ending a Query Call

You can also use this function on analogue telephones, where it can be
performed via the T-Net function key/menu (optional, see manual for the
telephone).
On ISDN and system phones, this function is performed via an existing
function key or via the menu (optional, see manual for the telephone).
Ending a Query Call
If you make a query call and the number is busy but there is no response, proceed as described
in one of the following steps.
• The subscriber called for the query call does not respond: Press the Flash key or the
Query key and dial 1.
You are now reconnected with the person waiting on the other line.
• The subscriber called for the query call is busy. Wait.
You will automatically be reconnected with the communication partner waiting on the
other line.
Note: On ISDN and system telephones, this function is performed via a
function key or via the menu (optional, see manual for the telephone).

Options during a Query Call

The following actions are possible during a query call:
Splitting
You can use at the splitting function to switch between your two communication partners.
Terminating One of the Two Calls
When you end a query call and want to continue talking with one of the communication
partners, you can specifically end the call with the other communication partner separately. Of
course, one of your communication partners can simply hang up so that you can continue
talking with the other communication partner alone.
140
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016