Selecting A Header File For Provisioning - Auerswald COMpact 4000 Operation Manual

Service and Maintenance
Provisioning for IP Telephones

Selecting a Header File for Provisioning

Proceed as follows:
• Using the configuration manager
1. Open the page Subscriber (scr.) > IP provisioning > File management.
2. Click Authorisations in the line of the provisioning file in question.
3. Select the desired subscriber(s):
• To grant access to only one subscriber: Select an subscriber in the left list field
under available subscribers and click
• To grant access to all subscribers:
Click
granted access).
or:
Select the Authorisation for all subscribers check box (all current and future
subscribers on the PBX are granted access). This option is not applicable on
Standard.xml files.
• To grant access to all subscribers to a group: Select a group in the Authorisation
for all subscribers to the group list field.
4. Click Save.
Selecting a Header File for Provisioning
Groups or individual subscribers can be assigned a header file with the specific addresses of
the files to be provisioned.
Proceed as follows:
• Using the configuration manager
Requirements:
• At least one *.xml file configured as header file
• No other header file assigned to the subscriber/group
1. Open the page Subscriber (scr.) > IP provisioning > File management.
738
(only those subscribers that are currently registered on the PBX are
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
.