Ringtones - Auerswald COMpact 4000 Operation Manual

Settings

Ringtones

Switching the Special Dial Tone On/Off
Ringtones
The PBX supports different ringtones for signalling calls on the internal subscribers. They can
be used for example to differentiate internal calls, external calls via different external numbers,
door calls and alarm calls using the ringtone.
Note:
Signalling is carried out by analogue devices as described (depending on the
end device used).
Some end devices (e.g., ISDN telephones and wireless, analogue
telephones) generate their own call tone/ringtone. For more information, refer
to the description of your end device.
On some system telephones the ringtones can be configured based on the
call type or the phone numbers (optional, see telephone manual).
Ringtones are displayed on analogue telephones as follows:
1 x long: 1 long tone (1 second), 4 second pause, ...
3 x short: 3 double tones, approx. 1 second pause, ...
1st special tone: Uninterrupted pulsing
2nd special tone: Continually repeating double tones (3 double tones in 5 seconds)
3rd special tone: 1 double tone, approx. 4 second pause, ...
4th special tone: 2 short tones, approx. 4 second pause, ...
5th special tone: 2 long tones, approx. 3 second pause, ...
6th special tone: 1 short and 1 long tone, approx. 4 second pause, ...
Alarm: Uninterrupted pulsing
Proceed as follows for configuration:
• Configuring the ringing tone for external calls.
– Using the configuration manager (on the following pages)
– Public switched tel. networks > ISDN connections > PTMP connection
– Public switched tel. networks > ISDN connections > PBX base numbers/trunk
bundles > Configure
– Public switched tel. networks > ISDN connections > Extension numbers PTP
connection
– Public switched tel. networks > ISDN connections > Additional PBX base
numbers
672
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016