Switching Automatic Call Take-Over On/Off - Auerswald COMpact 4000 Operation Manual

Functions
Waiting Field Function

Switching Automatic Call Take-over On/Off

Requirements:
• Configured subscriber or group number
1. Open the page Functions > Waiting Field.
2. In the Subscriber/group number for the Waiting Field list field, select the desired
subscriber or group.
Switching Automatic Call Take-over On/Off
If automatic call take-over is enabled, incoming calls are automatically put into the waiting field.
Proceed as follows:
• Using the configuration manager
1. Open the page Functions > Waiting Field.
2. Under Automatic call take over select one of the following options:
No automatic: Incoming calls must be put manually into the waiting field.
On busy: Incoming calls are automatically put into the waiting field if all waiting
field reception telephones are busy. (In this case, "busy" means that there is an
ongoing call in the active waiting field receptions or an outgoing or incoming
call is ringing. If a caller is waiting in the waiting field, this does not count as
"busy".)
After:: Incoming calls are indicated for a duration of x seconds in the waiting
field reception and then automatically put into the waiting field if not already
accepted manually.
3. Option After:: Enter the time duration in seconds in the After: entry field. Possible
entries:
1 to 120
508
seconds
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016