Auerswald COMpact 4000 Operation Manual page 480

Functions
Door Functions
Creating a Door Terminal
Note: Relays and switch inputs which are offered in the device template, but
are not needed, can be deleted. To do so, click
9. Enter the DTMF sequences which the connected door terminal uses as signal in the
DTMF sequence entry fields. Possible entries:
Digits and the characters * and #
Note: If default values have already been entered in the device template, the
entry fields will not be displayed. If you want to change these values, click
Expert.
10. In the Destination number list fields, select the required call destination. Or after
selecting Enter destination number, in the Destination number entry fields, enter
the required call destination. Possible entries:
External number
Short-code number
Internal number of the individual telephone
Internal telephone of the group
Note:
The call destination is first entered identically for all configurations. It can
bechanged afterwards.
If a door call should also be executed via VoIP accounts or GSM gateways,
in any case the external number must be entered with the corresponding city
code, even if it is the local prefix.
11. Click Save.
12. Click Close.
Note:
To change the settings of the just created door terminal, click Configure in
the line of the corresponding door terminal on the page Devices > Device
wizard.
To create further configurations for a door terminal, open the page Devices
> Door terminals and click Configure in the line of the corresponding door
terminal. The configuration is described in the following.
480
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
.