Auerswald COMpact 4000 Operation Manual page 149

External number
preceding exchange line access number)
Short code number
telephone: with preceding **)
Internal number of the individual telephone
Direct exchange line telephone: with preceding **)
Internal number of the group
exchange line telephone: with preceding **)
As soon as the subscriber being called picks up the receiver, you will make a third call.
Important: To use this function on ISDN and system telephones, the function
must be supported via a function key or via the menu by the respective
telephone (optional, see manual for the telephone).
4. Proceed as required.
• To connect the second and third communication partner and to perform a one-to-
one call with the first communication partner, press the Flash key or the Query
key and dial 4.
The second and the third communication partner are now connected with each
other.
Then return to conducting an individual call with your first communication partner.
• To connect the second and third communication partner and to terminate the call
with the first communication partner, hang up the receiver.
The second and the third communication partner are now connected with each
other.
The first call will be signaled by the PBX if it was an external call. The internal call
is disconnected.
Note: If the third communication partner is not ready to be transferred to the
second communication partner, press the Flash key or the Query key and
dial 1. You will then get back to the normal query call.
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Calling a Third Subscriber and Transferring to an Active Communication Partner
(for exchange line request type Internal telephone: with
(for exchange line request type Direct exchange line
(for exchange line request type Direct
(for exchange line request type
Telephoning
Transferring
149