Switching Cascading Of Call Forwarding For Subscribers On/Off - Auerswald COMpact 4000 Operation Manual

2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the only external calls check box under Settings.

Switching Cascading of Call Forwarding for Subscribers On/Off

If call forwarding has been configured for the internal destination of an existing call forwarding,
it is possible to reroute already forwarded calls (cascading).
If CF cascading is enabled, calls which have already been forwarded by a call forwarding, will
be rerouted to the new CF destination. The caller hears the dial tone until the call is accepted
(conversation). If the call cannot be switched, a busy signal is issued. Possible reasons:
• The CF destination is busy.
• The maximum call duration has been reached (after approx. 2 minutes).
During CF cascading, the PBX memorises the subscribers who have already been called for
this call. If the call is to be redirected by means of call forwarding to a destination number, which
has already been called during the cascading, there will be no further call forwarding. The call
will be treated as if there was no call forwarding available, e.g.:
• If the subscriber called last is busy, a busy signal will be sent.
• The call will be signaled to the last subscriber until the maximum call duration is reached
for the call.
Proceed as follows:
• Separately for subscribers
• Separately for configurations
• Using the configuration manager
Note: As described in the following, the setting is also possible via profiles (...
> Profiles > Configuration > Configure > ...). If the check box Profile-
controlled settings has been selected, the property set in the right-hand
column will apply. For assignment of the profile, see chapter Settings >
Profiles.
1. Open the following page:
COMpact 4000 - Firmware V6.6A - Installation, Operation and Configuration V03 03/2016
Switching Cascading of Call Forwarding for Subscribers On/Off
Functions
Call Forwarding
451